Check out your Company Bowl for anonymous work chats.
Bowls
Get actionable career advice tailored to you by joining more bowls.
Followed companies
Stay ahead in opportunities and insider tips by following your dream companies.
Job searches
Get personalized job recommendations and updates by starting your searches.
Texas Instruments interviews FAQs
Analog Designer applicants have rated the interview process at Texas Instruments with 3.2 out of 5 (where 5 is the highest level of difficulty) and assessed their interview experience as 80% positive. To compare, the company-average is 72% positive. This is according to Glassdoor user ratings.
Candidates applying for Analog Designer roles take an average of 19 days to get hired, when considering 5 user submitted interviews for this role. To compare, the hiring process at Texas Instruments overall takes an average of 24 days.
Common stages of the interview process at Texas Instruments as a Analog Designer according to 5 Glassdoor interviews include:
Presentation: 13%
Group panel interview: 13%
Phone interview: 13%
One on one interview: 13%
Other: 9%
Background check: 9%
Drug test: 9%
Skills test: 9%
IQ intelligence test: 9%
Personality test: 4%
Here are the most commonly searched roles for interview reports -
I applied through college or university. I interviewed at Texas Instruments (Calicut, Kerala) in Apr 2018
Interview
there were three rounds
1. Online screening test
2. Technical interview
3.HR interview
The test was purely on opamps, BJT, VLSI, RC and diode circuits and a bit of aptitude
the aptitude, analog and digital sections were separate and each section was given a specific time for each of the sections. 20 questions from each of the sections were given 30 minutes.
based on performance in test, they classify people for analog and digital seperately.
I was there for analog.
Technical round was purely on basics.Opamps, RC circuits step response. They didn't even see my resume.
I applied online. I interviewed at Texas Instruments (Tucson, AZ)
Interview
The interview process began with an initial screening round, followed by four comprehensive technical rounds that lasted approximately four hours in total. The technical questions were thorough, focusing heavily on Analog-to-Digital Converters (ADCs), Digital-to-Analog Converters (DACs), and broader mixed-signal architectures. The interviewers also placed a strong emphasis on foundational analog design basics.
Interview questions [1]
Question 1
Explain the effects of device mismatch in a current mirror and how you would mitigate it in both your schematic sizing and layout techniques
The interview had basic analog circuit questions- RLC networks with frequency analysis. few mosfet impedance calculations questions as well. Graphs of current and voltages in op-amps and RC circuits were also asked.
I applied online. The process took 2 weeks. I interviewed at Texas Instruments (Santa Clara, CA) in Feb 2022
Interview
Start with a survey that describes how you behave in workplace, then recruitment will assign you the interviews. 2 1hour session, 4 people total. Some behavioral and technical questions from both verification and design roles. You then talk to recruiter to decide which location/team you would like to be put on.
Interview questions [1]
Question 1
RC step response, bias generator, MOS with inductive load with an input step response, Vout and Iout plots. Show and describe a project you have done.