It was based on basic knowledge like rc, rl ckt and MOSFET based. They asked to draw the waveform of the output and they given that one MOSFET and connected capacitor at source then asked what would be the Vds
Interview questions [1]
Question 1
Give your introduction and little bit about internship
fundamental circuit intuition, problem-solving skills, and deep understanding of device physics rather than just rote memorization of equations. You will be expected to think out loud, draw waveforms, and analyze small-signal
Online Assessment followed by 2 rounds of technical interviews. Online Assessment consisted of 3 parts - Analog, Digital and Aptitude. Analog part mostly consisted of questions from RC circuits, Opamps, MOS Circuits, Oscillators.
I interviewed at Texas Instruments (Bangalore Rural)
Interview
I am only having only one round of interview
Where they asked mostly about rc circuits. Op amp basics and mosfet questions.
The interview almost happened for 1 hour and it is a good experience