If the source impedance is 50ohms, and you have 2dB of mismatch between the source and load, on what region of the smith chart would the load impedance be found?
System Specialist Interview Questions
60,714 system specialist interview questions shared by candidates
1) Introduction 2) Experience from current job. 3) Basic knowledge of FPGA programming languages.
You have access to two ports on the RF circuit of a mobile device, one port is at the antenna one at a 50 ohm resistor. Which port will you connect to test the circuit. why describe the advantage and disadvantage of each case.
Equivalent resistance of a resistor cube, with 1ohm resistor on each side.
scp command for copying to remote computer failing for 5 gb of file
among the questions most difficult was "what is domain controller" this was not difficult but among the questions this was difficult..
How many squares in a chess board
What is your favorite color?
fibonacci series,about my project
What do you consider to be your weaknesses?
Viewing 231 - 240 interview questions